If you don't want an automatic scan to be performed, disable the Automatic scanning setting on the PV-inverters menu. The GX Device will regularly (once every minute) scan the IP-addresses in this list in order to find new data cards, or reconnect to data cards whenever the connection was lost. When R 1 is large, C 1 is charged primarily through R 3 from the phase-shifted voltage appearing across C 2. This circuit will control from 5 to 95 of full load power, but is subject to supply voltage variations. If you don't want to wait for completion, enter an IP-address manually.Īll data cards found will be entered in the 'Detected data cards' list. second RC phase-shift network extends the range on control and reduces the hysteresis effect to a negligible region. Usually a scan is completed within a minute - though if you have a large subnet it may take much more time.

This scan will be performed during GX Device startup whenever the GX Device loses connection to a data card and a scan can also be initiated manually by selecting 'Press to scan'. It will scan all IP-addresses in the local network (that is, all IP-addresses within the netmask assigned to the GX Device) to check whether or not they are Fronius datamanager cards. They should be exactly the same as in the Settings –> Ethernet of the GX Device.Īs mentioned above the GX Device should find all Fronius inverters automatically. If you would like to connect the Fronius to be able to use the internet connection of your Local network, you have to set Gateway and DNS IP addresses on the Fronius as well. You may need to refer to the Fronius operating manual for how this is done for your Fronius Inverter model, The IP address ranges used on each interface should differ in the third segment.Īs an example: 192.168.10.1-254 for LAN IP's and 192.168.11.1-254 for WiFi IP's.Ĭonfigure the Fronius Datamanager to use an IP address on the same subnet, as described above. Use different IP subnets for the WiFi and wired LAN interface. Configuring multiple devices with exactly the same IP addresses will lead to network errors. The subnet is described by the first 3 segments in this case and so they have to be the same. The highest value, that can be set for this segment is 254.

If the LAN IP address and Subnet Mask of the GX Device is not configured yet, you will have to set it first.Īs an example, the IP address on the GX Device could be: 192.168.10.1 and the Subnet Mask: 255.255.255.0.Ĭonfiguring the Fronius to the same subnet means setting a manual IP address to: 192.168.10.2 and the same Subnet Mask of 255.255.255.0 on the Fronius.Įvery device on your LAN has to have a unique (different) IP address and so the last segment (.1/.2) in this example has to differ on every device on the same LAN. The important settings are the IP address and Subnet Mask. The IP configuration can be reviewed in Settings –> Ethernet. To do this, first have a look at the IP configuration your GX Device is using on that network. You will have to configure the IP address of the Fronius to be in the same subnet as the IP address of the GX Device.

Phase shift controller setup